serial_reset_device
Reset device via DTR/RTS sequence
How to use it
Project documentation lists serial_reset_device for the MCP Remote Access MCP server. Add the server to your MCP client (Claude Desktop, Cursor, Windsurf and others), then check which tools your installed version makes available. Tool availability can depend on configuration and credentials. A server handshake does not verify this tool’s behavior. See the full listing for setup details.
Install MCP Remote Access
uv pip install -e .Other tools in MCP Remote Access (25)
Connect by port name
Connect by VID / PID / serial / description match
Close a serial connection
ESP32-aware connect (BOOT/RESET sequence, auto-baud)
Wait/send step sequences (login prompts, AT flows)
Flush serial buffers
Show active serial connections
List available serial ports (with VID/PID, description, serial #)
Read available data
Read raw bytes back as hex
Send text data (with optional response read + configurable line ending)
Send a break signal
Send raw bytes as hex (binary protocols: Nordic DTM, HCI, etc.)
Set DTR line state
Set RTS line state
Wait for a pattern in the incoming stream
Check status / collect output of a background command
Connect to a host via SSH (password or key auth)
Close an SSH connection
Download a file via SFTP
Run a command on a connected host (sync)
Run a long-running command async, returns taskid
List all active background commands
Show active SSH connections
Upload a file via SFTP